Rode S1-B


Item Code: #582

Delivery Time : 5 Days

Availability: In stock

Extended Warranty

Studio recording quality
Rugged all-metal construction
Attractive satin-nickel finish
Heat-treated, high-strength mesh head
Custom designed integral 'plosive' screen
Ergonomically weighted & balanced
Low noise circuitry
Low handling noise
Complete with stand mount & zip pouch
Designed & manufactured in Australia

Operation Power: 48V
Output Impedance: The S1 will operate satisfactorily into a load impedance as
low as 1kOhm. If a load below this is used, the output signal
level will be reduced
The S1 output is balanced between pin 2 (hot) and pin 3
(cold). Pin 1 is ground
Acoustic principle: Externally polarized condenser, pressure
gradient transducer
Directional pattern: Supercardioid
Frequency range: 20Hz-20kHz
Polar pattern
Output impedance: 50 ohms
Signal/Noise ratio DIN/IEC 651: 75dB (1kHz rel 1 Pa; per IEC651, IEC268-15)
Equivalent noise: 18dBA SPL (per IEC651, IEC268-15)
Maximum SPL: 151dB (@ 0.7% THD into 1kOhm)
Sensitivity at 1 kHz into 1 kOhm: -46.5dB re 1 Volt/Pascal, (4.7mV @ 94dB SPL), +/- 2dB into 1kOhm
Maximum output voltage: +12.5dBu (@ 0.7% THD into 1kÎ)
Dynamic range of the mic. amplifier DIN/IEC 651: 132dB (per IEC651, IEC268-15)
Power (Supply voltage): Phantom supply voltage - 44V to 52V. Current consumption - 4.4 mA
Polarity: A positive acoustic pressure applied to the diaphragm results in a positive voltage excursion at pin 2 with respect to pin 3 at the output XLR connector
Connector: XLR 3F
Weight approx.: 10.58 oz